The Optical Receiver Rack






The purpose of the rack is to convert the optical signal from the antennas into 4-8 GHz electrical signals to feed the IF processor. It also can substitute a noise source to all 12 signals simultaneously, in order to calibrate the bandpasses of the following equipment.
The rack is mounted in the correlator room, vertically on the future WB correlator table.

It accepts 12  E2000/APC connectors  on its back panel (bottom, actually) :



Every input has a  red LED  that gets off when the laser signal is present with sufficient power.
The back panel also holds a yellow LED that blinks when CAN is active, and a pair of LEDs to indicate wether IF or noise source is selected.
For convenience these LEDs are repeated on the front (top, actually) panel.

Detailed information on the monitor&control section can be found in the Fo-Rx manual.





















Electrical diagram. An external SMA jumper allows for adjusting the noise source level or to inject a test signal.




Nominal signal values across the IF link