next up previous contents
Next: 11.3.3 Results of the Up: 11.3 The ``Standard Calibration Previous: 11.3.1 Inputs

11.3.2 Actions or Outputs

To calibrate your data, you need to do the following actions leading to the output calibration, in order:

1.
SELECT: Select the calibration parameters
2.
PHCOR: Radiometric phase correction, equivalent to a ``Monitor 0'', see A.Dutrey lecture.
3.
RF: Radio Frequency calibration
4.
PHASE: Instrumental phase calibration versus time
5.
EFF: Efficiency (Jy/K) calibration, to determine the flux densities of the amplitude calibrator. The inputs ``R1 Fluxes'' and ``R2 Fluxes'' should be used here.
6.
AMP: Amplitude calibration versus time
7.
PRINT: To produce the LaTeX and PostScript files containing the calibration curves (e.g.
28-feb-2001-x007.ps).
By typing GO, all the actions listed above are done sequentially. The reducer has just to type continue under CLIC (or use the ``Continue'' button in the top left menu) at each step of the calibration process.
next up previous contents
Next: 11.3.3 Results of the Up: 11.3 The ``Standard Calibration Previous: 11.3.1 Inputs
S.Guilloteau
2000-01-19